keywords:
Bookmark and Share



Front Back
       Required Crew
                 2
EMB-145    Certification                 Conditions
Day, Night, VFR, IFR, Icing
Max runway slope
+/- 2% of runway length
Runway surface
Paved
Max tailwind
10 kts.
Max temperture for aircraft
ISA +35 degrees C
Min/Max takeoff and landing pressure altitude
-1000', 8000' for ER/LR (-1000', 10000’ – XR)
Min/Max SAT at FL370
-65/-21.5 C
Min/Max SAT for takeoff
-40/52 C
Min TAT above FL250
-45 C
Min SAT below FL250
-54 C
MX inspection needed when landing below
 
-40˚ C
Vlo for gear retraction/extension
200/250kts
Vle
250 KTS
Va
200kts
Max flap ext speed for flaps 9
250kts
Max flap ext speed for flaps 18
200 kts
Max flap ext speed for flaps 22
200kts
Max flap ext speed for flaps 45
145kts
Max flap ext speed for flaps 45 for the XR
160kts
Above 10,000 with YD disengaged max speed for flaps 22 (XR)
180 KIAS
When flaps are extended to 45 degrees momentary airspeed deviations up to _____ are allowed.
155kts
Above 10,000 with YD disengaged max speed for flaps 45 (XR):
145kts
Max demonstrated crosswind
30kts
Is Mx required for non XR, when flaps are extended above 10,000'
No Mx is required
Max airspeed after takeoff/climb without retrimming
160kts
Max airspeed for turbulent air penetration below 10,000’
200kts
Max airspeed for turbulent air penetration above 10,000’
250 kts or M.63 whichever is lower
Max windshield wiper operating speed
170kts.
Do not operate windshield wiper
On a dry winshield
Max imbalance allowed between tanks
800lbs.
The Min/Max fuel tank temperature
-40˚ C
+52˚ C
Max N1
100%
Min and Max N2 (ER/LR)
                    57%                                                                          102.5
Min and Max N2 (XR)
54%
103.8%
For all models, min/max oil pressure <88% N2
34/110 psi
On ER/LR, min/max oil pressure >=88% N2
50/110 psi
On XR, min/max oil pressure >= 88% N2
48/110 psi
On EP/LR, Operation between 34 and 50 psi is permited during:
Takeoff and Go-around
On XR, operation between 34 and 48 psi is permited during:
Takeoff and Go-around
Max oil pressure may be exceeded during start if the oil temp is below___C. The engine must remain at IDLE until the oil presure is less than___psi.
21 degrees C

110psi
x of y cards